In tg3_chip_reset(), the PCI_EXPRESS change is taken from the Linux
tg3 driver. I am not sure what exactly it does (it is not documented
in the Linux driver), but it is necessary for the NIC to work
correctly.
Add "name" field to struct device to allow human-readable hardware device
names.
Add "dev" pointer in struct net_device to tie network interfaces back to a
hardware device.
Force natural alignment of data types in __table() macros. This seems to
prevent gcc from taking the unilateral decision to occasionally increase
their alignment (which screws up the table packing).
Strip down i386 PCI configuration space I/O to the bare minimum. A
typical build will now include 880 bytes of PCI support code, compared to
2327 bytes in Etherboot 5.4.
(There is a slight cost of around 5 extra bytes per access to a
non-constant config space address; this should be an overall win.
Driver-specific accesses will usually be to constant addresses, for
which there is no additional cost.)
Restructured PCI subsystem to fit the new device model.
Generic PCI code now handles 64-bit BARs correctly when setting
"membase"; drivers should need to call pci_bar_start() only if they want
to use BARs other than the first memory or I/O BAR.
Split rarely-used PCI functions out into pciextra.c.
Core PCI code is now 662 bytes (down from 1308 bytes in Etherboot 5.4).
284 bytes of this saving comes from the pci/pciextra split.
Cosmetic changes to lots of drivers (e.g. vendor_id->vendor in order to
match the names used in Linux).
I want to get to the point where any header in include/ reflects a
standard user-level header (e.g. a POSIX header), while everything that's
specific to gPXE lives in include/gpxe/. Headers that reflect a Linux
header (e.g. if_ether.h) should also be in include/gpxe/, with the same
name as the Linux header and, preferably, the same names used for the
definitions.
Michael Brown