[netdevice] Allow non-completion TX errors to be recorded
Allow TX errors to be recorded against a network device even when the
packet didn't make it as far as netdev_tx().
Inspired-by: Dominik Russenberger <dominik.russenberger@terreactive.ch>
Signed-off-by: Michael Brown <mcb30@ipxe.org>
[romprefix] Force PnP header to a 16-byte boundary for IBM BIOSes
IBM BIOSes ignore the PnP header offset stored at address 0x1a and
instead scan for the $PnP signature on a 16-byte boundary. (This
alignment is not mandated by the PnP specification.)
Force PnP header to a 16-byte boundary to work around these BIOSes.
Signed-off-by: Michael Brown <mcb30@ipxe.org>
[romprefix] Do not fall back to hooking INT19 by default
Several BIOSes (including most IBM BIOSes and many virtual machine
BIOSes) do not provide detectable PnP support, but will use the BEV
entry point for a PnP option ROM. On these semi-PnP BIOSes, iPXE will
respond to the absence of detectable PnP support by hooking INT19,
which disrupts the boot order.
BIOSes that genuinely require hooking INT19 seem to be very rare
nowadays. It may therefore be preferable to assume that the absence
of detectable PnP support indicates a semi-PnP BIOS rather than a
non-PnP BIOS.
Change the default behaviour so that INT19 will never be hooked unless
the compile-time option NONPNP_HOOK_INT19 is enabled. Leave the
redundant PnP detection routine in-place to allow for debugging via
the ROM banner line.
Signed-off-by: Michael Brown <mcb30@ipxe.org>
[romprefix] Remove special treatment for IBM BIOSes
Revert commit 38cd351 ("[romprefix] Attempt to gracefully handle
semi-PnP IBM BIOSes"), since the test for the "IBM " signature in %edi
is not sufficient to identify an IBM BIOS.
Signed-off-by: Michael Brown <mcb30@ipxe.org>
[ipv4] Include network device metadata in packet traces
(Ab)use the "ident" field in transmitted IPv4 packets to convey
metadata about the network device. In particular:
bits 0-3 represent the low bits of the "RX" good packet counter
bits 4-7 represent the low bits of the "RXE" bad packet counter
bits 8-15 represent the transmitted packet sequence number
This allows some relevant information about the internal state of the
network device to be read out from a packet trace from a non-debug
build of iPXE. In particular, it allows a packet trace containing
packets transmitted by iPXE to indicate whether or not any packets
have been received by iPXE.
Signed-off-by: Michael Brown <mcb30@ipxe.org>
Booting from an HTTP SAN will require HTTP range requests, which are
defined only in HTTP/1.1 and above. HTTP/1.1 mandates support for
"Transfer-Encoding: chunked", so we must support it.
Signed-off-by: Michael Brown <mcb30@ipxe.org>
[hermon] Remove temporary workaround for missing BOFM mport support
This reverts commit 15c1200 ("[hermon] Work around missing mport
support in current BOFM implementations").
Signed-off-by: Michael Brown <mcb30@ipxe.org>
[bofm] Report {slot,port} to {bus:dev.fn,mport} mapping on newer BOFM builds
Newer BOFM builds provide support for mapping multiple physical ports
to a single PCI bus:dev.fn via PCI VPD descriptions. These builds
will also leave the {slot,port} field intact, and will populate the
mport field with a meaningful value.
Older BOFM builds will zero out the {slot,port} field. A zero value
in this field may indicate either a genuine zero value (i.e. slot 0
first port) or an older build.
Signed-off-by: Michael Brown <mcb30@ipxe.org>
[romprefix] Attempt to gracefully handle semi-PnP IBM BIOSes
Some IBM BIOSes provide partial support for PnP: they will use the BEV
entry point but will not advertise PnP support. This causes iPXE to
hook INT 19, which disrupts the boot process.
Attempt to improve this situation by detecting an IBM BIOS and
treating it as a PnP BIOS despite the absence of a PnP signature.
Signed-off-by: Michael Brown <mcb30@ipxe.org>
[build] Fix building on mildly deranged versions of binutils
Some versions of binutils have curious concepts of what constitutes
subtraction. For example:
0x00000000000000f0 _text16_late = .
0x0000000000000898 _mtext16 = .
0x0000000000000898 _etext16 = .
0x0000000000000898 _text16_late_filesz = ABSOLUTE ((_mtext16 - _text16_late))
0x00000000000007a8 _text16_late_memsz = ABSOLUTE ((_etext16 - _text16_late))
This has interesting side-effects such as producing sizes for .bss
segments that are negative, causing the majority of addressable memory
to be zeroed out.
Fix by using the form
ABSOLUTE ( x ) - ABSOLUTE ( y )
rather than
ABSOLUTE ( x - y )
Reported-by: H. Peter Anvin <hpa@zytor.com>
Suggested-by: H. Peter Anvin <hpa@zytor.com>
Tested-by: H. Peter Anvin <hpa@zytor.com>
Signed-off-by: Michael Brown <mcb30@ipxe.org>
[int13] Catch INT 13,4b when no explicit drive number is present
This allows older versions of ELTORITO.SYS (such as the version found
on the FreeDOS installation CD-ROM) to use iPXE's emulated CD-ROM
drive.
Reported-by: Robin Smidsrød <robin@smidsrod.no>
Signed-off-by: Michael Brown <mcb30@ipxe.org>
[build] Accept EMBED=... as a synonym for EMBEDDED_IMAGE=...
Make the build command line less cumbersome by accepting
make DEBUG=int13 EMBED=test.ipxe
rather then
make DEBUG=int13 EMBEDDED_IMAGE=test.ipxe
Signed-off-by: Michael Brown <mcb30@ipxe.org>
Expose the multiple-SAN-drive capability of the iPXE core via the iPXE
command line by adding commands to hook and unhook additional drives.
Signed-off-by: Michael Brown <mcb30@ipxe.org>
[undi] Assume that interrupts are not supported if IRQ=0
Some PXE stacks (notably old Etherboot/gPXE stacks) will claim to use
the timer interrupt, rather than reporting that interrupts are not
supported. Since using the timer interrupt is equivalent to polling
anyway, we may as well genuinely poll these stacks.
Signed-off-by: Michael Brown <mcb30@ipxe.org>
[build] Run parserom.pl only on potential driver files
PCI_ROM() and ISA_ROM() macros occur only within driver files.
Running parserom.pl on non-driver files is therefore redundant.
Skip running parserom.pl on any files outside a "drivers" directory.
This reduces the time taken to generate build rules and dependencies
after a "make veryclean" by around 12%.
Signed-off-by: Michael Brown <mcb30@ipxe.org>
There is no plausible scenario I can think of in which "isset" would
be used with more than one argument. Simplify the code by specifying
that exactly one argument is required.
Signed-off-by: Michael Brown <mcb30@ipxe.org>
[hermon] Work around missing mport support in current BOFM implementations
Current BOFM versions are unable to create entries with mport>1, which
means that only the port 1 MAC address can be explicitly specified.
Work around this by using the provided MAC address as a base address
for all subsequent ports. For example, if BOFM assigns the address
00:1A:64:76:00:09 for port 1
then we will assign the addresses
00:1A:64:76:00:09 for port 1
00:1A:64:76:00:0a for port 2
Future BOFM versions that may correctly support mport will work with
this scheme without modification provided that the BOFM entries are
created in increasing order of mport. Since BOFM tools tend to
generate entries in increasing order (of slot, port, etc), this is not
an unreasonable compromise.
Signed-off-by: Michael Brown <mcb30@ipxe.org>
[build] Refuse to attempt building with the GNU gold linker
GNU gold (part of newer binutils builds) does not appear to be
designed to support generic linker functionality, since its source
code contains several Linux-specific hard-coded assumptions about the
layout of ELF binaries. Attempting to build iPXE using GNU gold will
generally cause some kind of "linker internal error".
Provide an explicit error message suggesting the use of GNU ld
instead.
Reported-by: Chris Hills <chaz@chaz6.com>
Signed-off-by: Michael Brown <mcb30@ipxe.org>
[tcp] Update ts_recent whenever window is advanced
Commit 3f442d3 ("[tcp] Record ts_recent on first received packet")
failed to achieve its stated intention.
Fix this (and reduce the code size) by moving the ts_recent update to
tcp_rx_seq(). This is the code responsible for advancing the window,
called by both tcp_rx_syn() and tcp_rx_data(), and so the window check
is now redundant.
Reported-by: Frank Weed <zorbustheknight@gmail.com>
Signed-off-by: Michael Brown <mcb30@ipxe.org>
Commit b5f5f73 ("[cmdline] Expand settings within each command-line
token individually") introduced a regression into the "isset" command:
it is now possible for command-line arguments to be empty strings, and
so "isset" cannot simply check for a non-empty argument list.
Restore previous behaviour by checking for the presence of any
non-empty arguments, rather than checking for a non-empty argument
list.
Reported-by: Nemtallah Daher <n.daher@csuohio.edu>
Tested-by: Nemtallah Daher <n.daher@csuohio.edu>
Signed-off-by: Michael Brown <mcb30@ipxe.org>
[tftp] Avoid setting current working URI to "tftp://0.0.0.0/"
Set the current working URI to NULL rather than to "tftp://0.0.0.0/".
Reported-by: Piotr Jaroszyński <p.jaroszynski@gmail.com>
Signed-off-by: Michael Brown <mcb30@ipxe.org>
Standardise on using init_editstring() to initialise an embedded
editable string, to match the coding style used by other embedded
objects.
Signed-off-by: Michael Brown <mcb30@ipxe.org>
Michael Brown