Merge commit 'indolent/natsemi'

src/config.h

@@ -18,7 +18,7 @@
  */
 
 #define	CONSOLE_FIRMWARE	/* Default BIOS console */
-#undef	CONSOLE_SERIAL		/* Serial port */
+#define	CONSOLE_SERIAL		/* Serial port */
 #undef	CONSOLE_DIRECT_VGA	/* Direct access to VGA card */
 #undef	CONSOLE_BTEXT		/* Who knows what this does? */
 #undef	CONSOLE_PC_KBD		/* Direct access to PC keyboard */

src/drivers/net/natsemi.h

@@ -0,0 +1,232 @@
+#define NATSEMI_HW_TIMEOUT 400
+
+#define TX_RING_SIZE 4
+#define NUM_RX_DESC  4
+#define RX_BUF_SIZE 1536
+#define OWN       0x80000000
+#define DSIZE     0x00000FFF
+#define CRC_SIZE  4
+
+struct natsemi_tx {
+	uint32_t link;
+	uint32_t cmdsts;
+	uint32_t bufptr;
+};
+
+struct natsemi_rx {
+	uint32_t link;
+	uint32_t cmdsts;
+	uint32_t bufptr;
+};
+
+struct natsemi_private {
+	unsigned short ioaddr;
+	unsigned short tx_cur;
+	unsigned short tx_dirty;
+	unsigned short rx_cur;
+	struct natsemi_tx tx[TX_RING_SIZE];
+	struct natsemi_rx rx[NUM_RX_DESC];
+
+	/* need to add iobuf as we cannot free iobuf->data in close without this 
+	 * alternatively substracting sizeof(head) and sizeof(list_head) can also 
+	 * give the same.
+	 */
+	struct io_buffer *iobuf[NUM_RX_DESC];
+
+	/* netdev_tx_complete needs pointer to the iobuf of the data so as to free 
+	 * it from the memory.
+	 */
+	struct io_buffer *tx_iobuf[TX_RING_SIZE];
+	struct spi_bit_basher spibit;
+	struct spi_device eeprom;
+	struct nvo_block nvo;
+};
+
+/*
+ * Support for fibre connections on Am79C874:
+ * This phy needs a special setup when connected to a fibre cable.
+ * http://www.amd.com/files/connectivitysolutions/networking/archivednetworking/22235.pdf
+ */
+#define PHYID_AM79C874	0x0022561b
+
+enum {
+	MII_MCTRL	= 0x15,		/* mode control register */
+	MII_FX_SEL	= 0x0001,	/* 100BASE-FX (fiber) */
+	MII_EN_SCRM	= 0x0004,	/* enable scrambler (tp) */
+};
+
+
+
+/* values we might find in the silicon revision register */
+#define SRR_DP83815_C	0x0302
+#define SRR_DP83815_D	0x0403
+#define SRR_DP83816_A4	0x0504
+#define SRR_DP83816_A5	0x0505
+
+/* NATSEMI: Offsets to the device registers.
+ * Unlike software-only systems, device drivers interact with complex hardware.
+ * It's not useful to define symbolic names for every register bit in the
+ * device.
+ */
+enum register_offsets {
+    ChipCmd      = 0x00, 
+    ChipConfig   = 0x04, 
+    EECtrl       = 0x08, 
+    PCIBusCfg    = 0x0C,
+    IntrStatus   = 0x10, 
+    IntrMask     = 0x14, 
+    IntrEnable   = 0x18,
+    TxRingPtr    = 0x20, 
+    TxConfig     = 0x24,
+    RxRingPtr    = 0x30,
+    RxConfig     = 0x34, 
+    ClkRun       = 0x3C,
+    WOLCmd       = 0x40, 
+    PauseCmd     = 0x44,
+    RxFilterAddr = 0x48, 
+    RxFilterData = 0x4C,
+    BootRomAddr  = 0x50, 
+    BootRomData  = 0x54, 
+    SiliconRev   = 0x58, 
+    StatsCtrl    = 0x5C,
+    StatsData    = 0x60, 
+    RxPktErrs    = 0x60, 
+    RxMissed     = 0x68, 
+    RxCRCErrs    = 0x64,
+    PCIPM        = 0x44,
+    PhyStatus    = 0xC0, 
+    MIntrCtrl    = 0xC4, 
+    MIntrStatus  = 0xC8,
+
+    /* These are from the spec, around page 78... on a separate table. 
+     */
+    PGSEL        = 0xCC, 
+    PMDCSR       = 0xE4, 
+    TSTDAT       = 0xFC, 
+    DSPCFG       = 0xF4, 
+    SDCFG        = 0x8C,
+    BasicControl = 0x80,	
+    BasicStatus  = 0x84
+	    
+};
+
+/* the values for the 'magic' registers above (PGSEL=1) */
+#define PMDCSR_VAL	0x189c	/* enable preferred adaptation circuitry */
+#define TSTDAT_VAL	0x0
+#define DSPCFG_VAL	0x5040
+#define SDCFG_VAL	0x008c	/* set voltage thresholds for Signal Detect */
+#define DSPCFG_LOCK	0x20	/* coefficient lock bit in DSPCFG */
+#define DSPCFG_COEF	0x1000	/* see coefficient (in TSTDAT) bit in DSPCFG */
+#define TSTDAT_FIXED	0xe8	/* magic number for bad coefficients */
+
+/* Bit in ChipCmd.
+ */
+enum ChipCmdBits {
+    ChipReset = 0x100, 
+    RxReset   = 0x20, 
+    TxReset   = 0x10, 
+    RxOff     = 0x08, 
+    RxOn      = 0x04,
+    TxOff     = 0x02, 
+    TxOn      = 0x01
+};
+
+enum ChipConfig_bits {
+	CfgPhyDis		= 0x200,
+	CfgPhyRst		= 0x400,
+	CfgExtPhy		= 0x1000,
+	CfgAnegEnable		= 0x2000,
+	CfgAneg100		= 0x4000,
+	CfgAnegFull		= 0x8000,
+	CfgAnegDone		= 0x8000000,
+	CfgFullDuplex		= 0x20000000,
+	CfgSpeed100		= 0x40000000,
+	CfgLink			= 0x80000000,
+};
+
+
+/* Bits in the RxMode register.
+ */
+enum rx_mode_bits {
+    AcceptErr          = 0x20,
+    AcceptRunt         = 0x10,
+    AcceptBroadcast    = 0xC0000000,
+    AcceptMulticast    = 0x00200000, 
+    AcceptAllMulticast = 0x20000000,
+    AcceptAllPhys      = 0x10000000, 
+    AcceptMyPhys       = 0x08000000,
+    RxFilterEnable     = 0x80000000
+};
+
+/* Bits in network_desc.status
+ */
+enum desc_status_bits {
+    DescOwn   = 0x80000000, 
+    DescMore  = 0x40000000, 
+    DescIntr  = 0x20000000,
+    DescNoCRC = 0x10000000,
+    DescPktOK = 0x08000000, 
+    RxTooLong = 0x00400000
+};
+
+/*Bits in Interrupt Mask register
+ */
+enum Intr_mask_register_bits {
+    RxOk       = 0x001,
+    RxErr      = 0x004,
+    TxOk       = 0x040,
+    TxErr      = 0x100 
+};	
+
+enum MIntrCtrl_bits {
+  MICRIntEn               = 0x2,
+};
+
+static uint32_t SavedClkRun;	
+
+/* CFG bits [13:16] [18:23] */
+#define CFG_RESET_SAVE 0xfde000
+/* WCSR bits [0:4] [9:10] */
+#define WCSR_RESET_SAVE 0x61f
+/* RFCR bits [20] [22] [27:31] */
+#define RFCR_RESET_SAVE 0xf8500000;
+
+/* Delay between EEPROM clock transitions.
+   No extra delay is needed with 33Mhz PCI, but future 66Mhz access may need
+   a delay. */
+#define eeprom_delay(ee_addr)   inl(ee_addr)
+
+enum EEPROM_Ctrl_Bits {
+	EE_ShiftClk   = 0x04,
+	EE_DataIn     = 0x01,
+	EE_ChipSelect = 0x08,
+	EE_DataOut    = 0x02
+};
+
+#define EE_Write0 (EE_ChipSelect)
+#define EE_Write1 (EE_ChipSelect | EE_DataIn)
+
+/* The EEPROM commands include the alway-set leading bit. */
+enum EEPROM_Cmds {
+  EE_WriteCmd=(5 << 6), EE_ReadCmd=(6 << 6), EE_EraseCmd=(7 << 6),
+};
+
+/*  EEPROM access , values are devices specific
+ */
+#define EE_CS		0x08	/* EEPROM chip select */
+#define EE_SK		0x04	/* EEPROM shift clock */
+#define EE_DI		0x01	/* Data in */
+#define EE_DO		0x02	/* Data out */
+
+/* Offsets within EEPROM (these are word offsets)
+ */
+#define EE_MAC 7
+#define EE_REG  EECtrl
+
+static const uint8_t natsemi_ee_bits[] = {
+	[SPI_BIT_SCLK]	= EE_SK,
+	[SPI_BIT_MOSI]	= EE_DI,
+	[SPI_BIT_MISO]	= EE_DO,
+	[SPI_BIT_SS(0)]	= EE_CS,
+};
+